Compak E8 OD - Page 23

ORIGINAL INSTRUCTIONS | Ref. quality process 002/03 | v. 07/01/2016 | K06307
22
Following these steps will ensure that the grinder is clean and ready for use.
We do not recommend the taking apart of the grind assembly unless changing burrs,
or removing a blockage/obstruction in the grind chamber. Removal of the grind
assemblyshouldbeperformedbyaqualiedservicetechnician.
11.5.Cleaningtheoutsideofthegrinder
Tocleantheexteriorofthegrinder,rstwipewithadrysoftcloth,andthengently
wipe with a damp soapy cloth.
11.6.Cleaningthetouchscreen
Proper cleaning should be done with a soft, damp microber towel. Preferably
distilled water or other cleaning product specically designed for touch screen
cleaning.
Turn off the grinder and gently wipe off the screen using a circular motion.
12. MAINTENANCE
12.1.Generalwarning
Before performing any type of maintenance you should:
• Always turn OFF the main power switch to the off position ( ).
• If the grinder is jammed, unplug it from the power source and contact an
authorizedservicetechnician.
Not following these warnings can compromise the safety of the grinder as well as
the user.
12.2.Generalmaintenanceofthegrindchamber
To guarantee the efciency andcorrect operationofthe grinder, itis essential to
follow manufacturer instructions and ensure that all maintenance work is carried
outbyqualiedstaff.
Dull burrs will result in; a lower quality grind, greater heat generation in the coffee
andgrinder,increasedelectricalconsumption,andnallyitputsadditionalstresson
the grinder motor.