Battery Cut-out
12/24V DC operation only
The built in battery cut-out system is designed to
protect your 12 volt battery source once the available
voltage falls to 10.5V DC (12 volt input) and 21.0V DC
(24 volt input). Once your battery is recharged and
above these cut-out levels the DualZone Freezer/
Refrigerator will operate normally.
Low voltage supply to the appliance can result in
poor cooling performance and cause damage to the
supply battery.
AC Power Connection
The DualZone Freezer/Refrigerator is supplied with
an approved 3 pin AC Power Lead and this must not
be modied or lengthened.
When connecting to AC power ensure that the
power socket is switched “off”. Plug the AC Power
Lead into the AC socket on the appliance and then
plug the other end of the AC Power Lead into the AC
supply and switch on.
The temperature is adjusted by turning the required
control in a clockwise direction for cooler & anti-
clockwise for warmer settings. The temperature in
each compartment is then displayed on the LCD
digital readouts located on the control panel.
The LCD read on the left is for the freezer compartment
with the refrigerator compartment read out on the right.
The tolerance for the LCD display is +/- 3 degree.
Normal Speed –
Fast Freeze Function
The Fast Freeze function can be used when the cabinet
temperature needs to be lowered quickly. By selecting
the Fast Freeze function, the speed of the compressor
will be increased resulting in quicker pull down times.
Note: When the Freeze function is selected the
power draw from the compressor will also increase
and therefore increase the power consumption. It is
recommended that the Fast Freeze function only be
operated for a maximum of 60 minutes per at any one
time.
COMPRESSOR ON
To Next Page
Loading...
