5–4 Hardware Guide
Drives
Removing a Disc from the CD or DVD Drive
1. Turn on the computer.
2. Press the eject button on the front panel of the media tray to
open it.
3. Remove the disc.
4. Slowly pull out the tray until it is fully extended.
5. Remove the disc from the tray. Handle it by the edges, not the
flat surfaces.
6. Place the disc in its protective case.
7. Close the media tray.
Changing the Startup Sequence
The computer can start up from most bootable media or devices.
A bootable medium or device contains files needed by the
computer to start up and operate properly.
When more than one bootable medium or device is in the system,
the computer selects the medium or device to start from by
searching sequenced locations. The startup sequenced for this
computer is first the diskette drive, second the optical drive, and
third the hard drive.
You can change the sequence in which the computer searches for
a startup medium or device by selecting the Boot Device menu in
the PhoenixBIOS Setup Utility (PSU). To run PSU, press
F10
during system startup.
To Next Page
Loading...
