EasyManua.ls Logo

Compaq dc7700 - Convertible Minitower PC - Page 16

Compaq dc7700 - Convertible Minitower PC
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
5. 786D
6. 786E
To verify this in your system:
1. Press F10 at boot time to enter Setup.
2. Select File > System Information to verify the correct system BIOS.
One of the USB flash media devices listed below:
1. HP Drive Key.
2. M-Systems USB DiskOnKey(R).
Microsoft Windows (Win 95 OSR2 or later) Startup diskette or DOS Bootable diskette with fdisk.exe
and sys.com files on the diskette.
To create a bootable flash media:
1. Turn off power to the computer.
2. Insert the USB flash media device into any of the computer USB ports.
NOTE: Unplug all USB storage devices (except USB Floppy drive) connected to the system other than
the USB flash media device that you plan to make bootable.
3. Insert Startup diskette or DOS Bootable diskette into the floppy drive.
4. Turn on power to the computer to boot from the Startup diskette.
5. Run Fdisk from the A:\ prompt by typing Fdisk and, then pressing Enter.
6. If prompted, select Yes to enable Large Disk support and answer Yes to any other questions that
appear on the screen.
7. Select option 5 to show multiple drives in the system. Write down the partition drive letter that has
been assigned to the USB flash media device. The drive letter is required to complete step 9. The drive
letter should also display the respective capacity (in Megabytes) of the USB flash media device.
IMPORTANT: Data loss can occur if the correct drive letter is not noted.
8. Exit the Fdisk program by pressing the Esc key several times until you are back to the A:\ prompt.
9. At the A:\ prompt, type Sys
X:
where
X:
is the drive letter for the USB flash media device noted in
Step 7 above. Reconfirm that you have entered the correct drive letter for the USB flash media device.
If confirmed, press Enter. You will then see the message “System transfer successful” if successful.
IMPORTANT: Make sure you have typed the correct drive letter noted in Step 7 or data loss can
occur.
10. Remove the diskette and reboot the system. Do not remove the USB flash media device from the port
it was originally inserted.
11. The system will boot the USB flash media device as drive C:
12. Any of the supported systems can now be booted from this USB flash media device.

Other manuals for Compaq dc7700 - Convertible Minitower PC

Related product manuals