2-8
Using Intelligent Manageability
Writer: Dianne Fielden Saved by: Troy Witte Saved date: 07/24/97 4:42 PM
Pages: 28 Words: 6156 Template: c:\template\commercial\comm.dot
File Name Ch2.doc Part Number 308336-001
1. Turn on the computer.
2. When the F10 Setup message appears in the lower-right
corner of the screen, press the F10 key.
✎
If you do not press the F10 key while the message is
displayed, you must turn the computer off, then on
again to access the utility.
3. Press the Enter key to bypass the welcome screens and
display the main menu.
4. From the main menu, select Computer Setup, and press the
Enter key.
5. Select the Built-In Devices option.
6. Select the Security Management option.
7. Locate the Setup Password option and select Enable Setup
Password.
8. Follow the instructions on the screen to establish a setup
password, then select OK.
9. Choose any other setup password preferences, then select
OK to exit the security management screen.
For more information about the various screen and
configuration options, refer to Chapter 5, “Using Compaq
Utilities.”
10. Select File, Save Changes and Exit from the menu bar near
the top of the screen.
Establishing a Power-On Password Using Computer Setup
Establishing a power-on password through Computer Setup
prevents access to the computer when power is turned on,
unless the password is entered. The password must be entered
each time the computer is turned on, when the key icon appears
on the monitor.
To Next Page
Loading...
