Reference Guide
5-7
Writer: Dianne Fielden Saved By: Holly Jahangiri Saved Date: 07/24/97 4:41 PM
Pages: 10 Words: 1508 Template: c:\template\commercial\comm.dot
File Name Ch5.doc Part Number 308336-001
Using the Main Screen Menu Bar
The menu bar near the top of the main Computer Setup screen
includes the following options: File, View, and Help.
■
Use the File menu to:
❏
Save and Restore System Configuration (Replicated
Setup)
❏
Save Changes and Exit
❏
Exit without Saving Changes
❏
Set Defaults and Exit
✎
For more information about Replicated Setup, refer to
Chapter 2, “Using Intelligent Manageability.”
■
Use the View menu to view DMA, I/O, IRQ, and Memory
settings.
Computer Checkup (TEST)
Use Computer Checkup (TEST) in the following instances:
■
To determine if all devices are recognized by the system
and functioning properly. Running TEST is optional, but
recommended, after you install or connect a new device.
■
To save, print, or display the information generated by
TEST. It is recommended that you run TEST and have the
printed report available before placing a call to the Compaq
Customer Support Center.
■
To assist your Compaq authorized dealer, reseller, or
service provider in analyzing the system by allowing the
service provider to reproduce the same environment on
another computer for testing.
To run Computer Checkup (TEST), complete the following
steps:
1. Turn on only the external devices that you wish to test.
You may wish to leave the printer connected to log error
messages.
2. Access the Compaq Utilities menu.
3. From the Compaq Utilities menu, select Computer
Checkup (TEST).
To Next Page
Loading...
