2-12
Using Intelligent Manageability
Writer: Dianne Fielden Saved by: Troy Witte Saved date: 07/24/97 4:42 PM
Pages: 28 Words: 6156 Template: c:\template\commercial\comm.dot
File Name Ch2.doc Part Number 308336-001
Locating the Password Jumper on the System Board
4. Reassemble and restart the computer. Your password is
disabled and cleared.
✎
When you restart the computer, and the screen displays
the message: “system options not set,” you should verify
the system date and time.
To establish new power-on and Setup passwords, you must set
switch SW1, position 1, back to the OFF position, clear CMOS,
and go to F10 Setup. For detailed instructions, refer to the
section “Establishing a Power-On Password Using Computer
Setup” earlier in this chapter.
Clearing Power-On Password and the Setup Password
To clear both the power-on password and the setup password,
clear the CMOS. See Appendix I, “System Board Jumpers and
Switches,” for more information.
To Next Page
Loading...
