3-6
Using Network Communications
Writer: Your Name Saved by: Troy Witte Saved date: 07/24/97 4:42 PM
Pages: 6 Words: 1022 Template: c:\template\commercial\comm.dot
File Name Ch3.doc Part Number 308336-001
5. Select Duplex Settings and change the value from AUTO
to Full or Half, depending on the capabilities of your
network.
6. Exit the Network control application.
You will be prompted to restart your computer in order for
the changes to take affect.
Installing the
Network Drivers
The device drivers in the network software enable the computer
to communicate with the network.
✎
Device drivers are supplied for Windows NT. If you are
using another operating system, device drivers may be
installed from files included with the network operating
system or device driver files available from Compaq.
Complete instructions for installing the network device drivers
are available in the file: C:\CPQNET\README.TXT.
Changing the Default Configuration
To change the default configuration settings, run the Computer
Setup utility. Refer to Chapter 5, “Using Compaq Utilities,” for
more information.
To Next Page
Loading...
