Drives
Hardware Guide 5–7
Some devices must be enabled in Computer Setup before they can
be included in a MultiBoot sequence.
Enabling Bootable Media and Devices for
MultiBoot
The computer can start by default from the following media and
devices:
■ Any bootable hard drive
■ Any bootable diskette in the external diskette drive
■ Any bootable diskette (but not a SuperDisk LS-120 or ZIP
disk) in an optional docking base
■ Any bootable peripheral interconnect (PCI) NIC in an
optional docking base
The computer can start from the following media and devices
only if the devices are enabled for inclusion in MultiBoot:
■ Any bootable diskette or CD in an optional diskette drive or
CD drive connected by USB to the computer or to an optional
docking base
■ Any internal NIC
To enable bootable media in USB drives or an internal NIC for
inclusion in MultiBoot:
1. Turn on or restart the computer, then press
F10 while the
F10 = ROM Based Setup message is displayed in the
lower-left corner of the screen.
❏ To change the language, press F2.
❏
For navigation instructions, press F1.
To Next Page
Loading...
Need help?
General