Hardware Guide 7–1
7
External Device Connections
External devices can be physically connected to the computer or
to a docking base. In addition, some computer models can
provide connections between infrared-equipped devices or
wireless communication equipment. Refer to the "A Look at the
Computer" section in this guide to locate the connectors on your
computer or to the guide included with your docking base. This
chapter provides procedures for connecting external devices to
the computer.
Connecting an External Monitor
Ä
CAUTION: To prevent damage to the computer, turn off the monitor
before connecting it to the computer or disconnecting it from the
computer. To prevent damage to the computer display, do not place
an external monitor or any other object on top of the computer
when the computer is closed.
To connect an external monitor:
1. Turn off the monitor.
2. Plug the monitor signal cable into the external monitor
connector on the rear panel of the computer.
3. Plug the monitor power cord into a properly grounded
electrical outlet.
4. Turn on the monitor.
To Next Page
Loading...
Need help?
General