External Device Connections
Hardware Guide 7–7
Connecting a Modem or NIC
The RJ-11 jack and the RJ-45 jack allow computer models with
an internal modem, internal NIC (network interface card), or both
to connect to a networked interface. You will need to purchase the
modem and network cables if they are not provided with the
computer.
Modem models will need an RJ-11 cable. To connect the cable:
1. Plug one end of the RJ-11 cable into the RJ-11 jack on the
computer. If the RJ-11 cable contains a noise suppression
circuit, which prevents interference with TV and radio
reception, orient the cable so that the noise suppression
circuitry is closest to the computer.
2. Plug the opposite end of the cable into a standard telephone
wall jack. Or, if applicable, plug the opposite end of the cable
into the phone plug adapter, which then plugs into the wall
jack. Some countries may require an adapter to connect the
modem to the telephone wall jack.
The NIC models will need an RJ-45 cable. To connect the cable:
1. Plug one end of the RJ-45 cable into the RJ-45 jack on the
computer.
2. Connect the other end of the cable into the network jack.
For information about configuring communication software or
drivers, refer to the Modem and Networking guide.
Connecting to Wireless Devices
The MultiPort allows connection of a wireless device to the
computer. The wireless device provides connection between the
computer and a networked access point. Refer to the
documentation included with the wireless device for hardware
and software installation procedures.
To Next Page
Loading...
Need help?
General