Adding System Memory and Upgrading the Internal Hard Drive
3-8 Quick Setup & User’s Guide
Upgrading the Primary Hard Drive
The primary hard drive is a 3.5-inch hard drive located on the left side of the
Personal Computer, under the MultiBay.
1. Exit all software applications, shut down the operating system software,
turn off the Personal Computer and any external devices, then disconnect
the power cord from the power outlet.
2. Remove the left access panel. Refer to “Removing and Replacing the Side
Access Panels” on page 3-2.
Removing the Internal Hard Drive
3. Pull the release lever 1 toward the front of the personal computer.
4. Slide the drive 2 forward and away from the personal computer.
5. Disconnect the flat ribbon data cable 3 from the hard drive by pulling up
on the green tab on the cable end.
QuickSetup_UsersGuide.book Page 8 Wednesday, May 30, 2001 9:36 AM
To Next Page
Loading...
