User’s Guide 1-5
Writer: M. Silvetti Saved By: Marianne Silvetti Saved Date: 03/03/98 2:30 PM
Pages: 26 Words: 3913 Template: c:\msoffice\templates\normal.dot
File Name Ch1appa.doc Part Number 284986-002
Using USB Connectors
The base of the monitor has five Universal Serial Bus (USB)
connectors. Four of these connectors, 1, 3, 4, and 5, are for
connecting USB compatible Plug and Play devices such as a
keyboard, mouse, or video camera. USB connector 2 is used to
connect the USB signal cable to the computer. The USB signal
cable is included with the monitor.
Using BNC Connectors
A signal cable with BNC connectors may be used in place of the
15-pin signal cable. To connect two computers to the monitor, a
BNC connector may be used together with the 15-pin signal
cable. If you have separately purchased a signal cable with BNC
connectors, use the following instructions to connect the signal
cable to the monitor.
✎
Fault Management and Asset Control are not supported by the
monitor when BNC connectors are used.
To Next Page
Loading...
Need help?
General
