Compaq S920 User Manual

22 Compaq S920 Color Monitor User’s Guide
5/10/01
File: Agency.fm
Power Cord Set Requirements
If you were not provided with a power cord for your computer,
you should purchase a power cord that is approved for use in your
country.
The power cord must be rated for the product and for the voltage
and current marked on the product's electrical ratings label. The
voltage and current rating of the cord should be greater than the
voltage and current rating marked on the product. In addition, the
diameter of the wire must be a minimum of 0.75 mm² or 18AWG,
and the length of the cord must be between 6 feet (1.8 m) and 12
feet (3.6 m). If you have questions about the type of power cord to
use, contact your Compaq authorized service provider.
A power cord should be routed so that it is not likely to be walked
on or pinched by items placed upon it or against it. Particular
attention should be paid to the plug, electrical outlet, and the
point where the cord exits from the product. The monitor power
supply is provided with Automatic Line Switching (ALS). This
feature allows the monitor to operate on input voltages between
100-120V or 220-240V.
The power cord set (flexible cord or wall plug) received with the
monitor meets the requirements for use in the country where you
purchased the equipment. For more information on power cord
set requirements, contact your Compaq authorized dealer, reseller
or service provider.

Compaq S920 Specifications

General

Screen Size	19” (48 cm) visual diagonal Viewable screen size 18” (46 cm) Anti-Glare Coating
Dot Pitch	0.26 mm (Diagonal) 0.22 mm (Horizontal)
Display Area Default	262 x 350 (mm) typical
Full Scan (H x W)	276 x 368 (mm), depends on signal timing
Display Colors	Infinite
Max. Resolution	1600 Dots x 1200 Lines
Compatibility	All graphic modes with horizontal frequencies between 30 KHz to 96 KHz
Synchronization Horizontal:	30 to 96 KHz
Synchronization Vertical:	50 to 160 Hz
Max Pixel Clock	202 MHz Max.
Input Signal	Video RGB Analog Sync. TTL Separate
Signal Cable	15-pin D-sub connector
Power Input Voltage Frequency	European Models: 200 to 240V AC Other Models: 100 to 240V AC 50-60 Hz
Current Rating	2.0 Amps
Power Consumption	120 W (Max.)

Weight and Dimensions

Dimension (W x H x D)	452 x 459 x 468 mm (approximate) 17.8” x 18.1” x 18.4”
Weight	20 kg Max. 44 lb Max.