5–64 Maintenance and Service Guide
Removal and Replacement Procedures
7. Remove the following screws:
1 One silver Phillips PM2.5×4.0 screw that secures the
expansion port 2 bracket and fan/heat sink assembly to the
system board
2 Two Phillips PM3.0×6.0 screws on each side of the
external monitor port that secure the fan/heat sink
assembly to the system board
3 Two slotted M1.5×9.0 screws on each side of the
expansion port 2 that secure the expansion port bracket
and fan/heat sink assembly to the system board
Removing the Fan/Heat Sink Assembly Screws, Part 3
To Next Page
Loading...
