Heat pump pool heater _12
CONNECTING ELECTRICAL CONDUCTORS
Bomba de calor eléctrica de bajo consumo _59
All wires must be connected according to the wiring diagram located on the inside surface of the electrical compartment
panel of the heat pump.
A disconnect switch must be installed near the outdoor unit for easy disconnection of power to the heat pump pool heater.
CAUTION
Operating the unit with improper line voltages constitutes abuse and will affect unit reliability and operation. Do not install
a system where voltage or phase imbalances may occur above or below permissible limits.
WARNING
Disengage main power disconnect before attempting installation
To Next Page
Loading...