Bomba de calor eléctrica de bajo consumo _64 Heat pump pool heater _7
GENERAL INFORMATION ON HEAT PUMP OPERATION
A: WATER INLET
B: WATER OUTLET
A
B
Beginning of season:
> Make sure that the electrical breaker of the pool heat pump is in the OFF position.
> Be certain the water lines and the heat pump are reconnected and/or drain valves are closed.
> Clean the pool filter and make sure the water is flowing adequately through the pool return line (6 m
3
/h to 15 m
3
/h).
> Complete your normal preparation and/or cleaning of the pool for the start of the season.
> Switch ON the breaker of the heat pump electrical supply line.
> Then all you have to do is start the unit and adjust the temperature at the desired value.
End of season (Winterizing)
> Switch OFF the breaker of the heat pump electrical supply line.
> You must empty the unit of all water. You simply have to disconnect the WATER INLET and WATER OUTLET lines by
unscrewing the two unions at the front of the unit. To completely eliminate the water in the heat exchanger, draw out the
water that is below the level of the water entry using a small hose or a vacuum for liquids.
It is recommended to cover the heat pump with a protective cover that is available from your dealer.
DIAGRAMA DE DESMONTAJE DE LA BOMBA DE CALOR
To Next Page
Loading...