7
Compool Cp3400
6. Systems with separate main drain and skimmer lines can use a 3-port valve to balance the
flow.
7. Plumb cleaner pump after the return valve to the pool return line.
8. A Valve Actuator can be used to direct pool return water to a waterfall. This eliminates the
need for an additional pump.
9. Plumb solar feed and return lines between the filter and heater. Install 3-port solar valve at
the feed line. Use Compool solar valve (model SOL-2T), to allow automatic draining of
panels.
10. A solar booster pump should be used when distance to panels exceeds 200’, or panels are
elevated higher than 25’.
11. Glazed solar panels require a drain valve (model HW-5B) to allow draining of panels.
This prevents damage from overheating water. Install drain valve at solar feed line and
connect to the pool fill line.
Equipment Location
With the exception of the Spa-side Remote, all equipment must be located at least 10’ from the
water’s edge. Locate equipment in the following locations.
LX-3400 Power Center - at the equipment site.
CP-3400 Control Panel - inside the house or other weather-protected area.
CVA-24T Valve Actuators - at valves to be motorized.
SNS-KIT2 Water Temperature Sensor - at the filter pump. Freeze Temperature
Sensor - at equipment pad.
To Next Page
Loading...