Page | 7
Louroe Intercom and Microphone Components:
Speaker / Mic Specifications:
Output: Line Level 90 dB @ 1KΩ
Sensitivity Mic: -65 dB ± 4 dB
Current drain: 4 mA
Speaker: 4”, 8Ω w/70V Transformer
Power Rating: 4W
Face Plate Dimensions: 6 ½” H x 8” W
Backbox for TLM-W:
Surface Mount Box (metal): 6 ½” H x 8” W x 2 ¾” D
Flush Mount Box (Plastic): 5” H X 6 7/8” W x 2 7/8”D
Total including Flange: 6 ¼” x 8” W X 2 7/8” D
Base Station Specifications:
Input Sensitivity: .78 Vrms
Monitor power Output: 1.5W @8Ω
Talk back power Output: 1.5W into 70V line
Input sensitivity: -55dB
Audio Line output imped: 600Ω or Higher
Audio input impedance: 10KΩ
Audio frequency response: 100 Hz to 10 kHz
Power input: 24Vdc, 1A or 24 Vdc, 1.5A
Dimensions: 8” W x 10” D x 2 ¼” H
Shipping Weight: 10lbs (4.5 Kg)
Intercom/Audio Cable:
Intercom Cable: West Penn 356 or equivalent
One (1) 4 Conductor Shielded with Ground wire, 20AWG cable, Non-twisted Pair
and Stranded Coming out into a single gang box.
Audio Cable: West Penn 452 or equivalent
One (1) 2 Conductor Shielded with Ground wire, 20AWG cable, Non-twisted Pair
and Stranded
Cables above Ceiling: Direct Runs
- 10ft. Service Loop in the Patient Room and Control Room
- Soldered to a RCA Connector with 10 ft of Service Loop
Red: Source
Back: Negative
Drain: Negative
To Next Page
Loading...