CompuSTAR CM3000 - Adjusting System Settings

Page 14Page 13
Adjusting the Car Siren Volume:
In order to decrease the chirping volume of the siren, cut the loop located on
the siren.
Adjusting the Shock Sensor Sensitivity:
In order to the shock sensor sensitivity, turn the screw located on the
sensor clockwise. In order to decrease the sensitivity, turn the screw located
on the sensor counter-clockwise. Turning the screw just a small amount can
make a big difference so make sure you recheck the sensitivity after each adjust-
ment.
Setting
AUX No.
2-9
On
Access to passive mode through a remote
Non setting of passive mode Setting of passive mode
Button II
Button III
All outputs are connecting with
Channel Expander through AUX1.
Button I Button II
Button II Button III
AUX 1,
AUX 2
Button III
Button IV
Button II-
Button III-
Button IV-
off
AUX 1
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
Output