- 22 -
b. Press the “SET” button again and hold it down and press
the “PROG” button, too. At this point the device gets into
programming mode and the abbreviations indicating the days of
the week (MON TUE WED THU FRI SAT SUN) are ashing on
the display.
c. Select the day to be programmed using the large and
buttons on the front panel of the device (MON indicating
Monday, TUE indicating Tuesday etc.). If you wish to create
the same program for each day of the week, it is reasonable to
choose all days of the week simultaneously (by selecting MON
TUE WED THU FRI SAT SUN together), this way there is no need
to perform separate programming of the days. After selecting the
desired day(s), press the “PROG” button.
d. At this point the temperature of switch PROG should be set,
To Next Page
Loading...
