- 23 -
which is indicated on the display of the device by ashing the
temperature value to be set ( °C by default). Set the desired
temperature using the large and buttons, then
press the “PROG” button.
e. Then, the start time of switch PROG should be adjusted,
which is indicated on the display of the device by ashing the time
value to be adjusted ( by default). Set the desired time using
the large and buttons, then press the “PROG” button.
f. Following this, the temperature of switch PROG
should be set, which is indicated on the display of
the device by ashing the temperature value to be set
( °C by default). Set this temperature level of switch
PROG using the large and buttons, then
press the “PROG” button.
g. The next step in programming is the adjustment of the start
time of switch PROG , which is indicated on the display of
the device by ashing the time value to be adjusted ( by
default). The adjustment process of switches PROG ‒ PROG
can be done (the same way as switch PROG is adjusted) by
repeating the “e”-“f” steps.
To Next Page
Loading...
