- 24 -
If you do not want to activate any more switches for the selected
day(s), then press the “PROG” button without changing the
start time of the next switch from the default . This way the
programming of the selected day(s) is nished, the thermostat
oers another day to be programmed and the programming can
be continued from step “c”.
If all the switches (PROG – PROG ) are activated for the
selected day(s), then after setting the temperature value of
PROG , the programming of the selected day(s) is nished,
the thermostat oers another day to be programmed and the
programming can be continued from step “c”.
h. The adjusted program can be saved by pressing the “SET”
button. After approximately 1 minute, the adjusted program is
automatically saved. Afterwards, the device goes back to the
main screen.
If you wish to copy the program of the day(s) selected in step “c” to other
days, you can easily do so using the “COPY” button as described in
Chapter 4.4.
To Next Page
Loading...
