- 27 -
• The number of activated switches can be increased at will
as described in Chapter 4.3.
• A previously activated switch can be deactivated by
setting its start time to using the large and
buttons (or by pressing the “DAY” button once),
and then pressing the “PROG” button. After this, if the
deactivated switch was an intermediate one, then the
serial numbers of the remaining switches will be updated.
• If you wish to nish modifying the program of the selected
day, then press the “PROG” button and hold it down for
at least 3 seconds. After this, the modication can be
continued by selecting another day. When nished with all
the modications, press the “SET” button to save them.
After approximately 1 minute, they are automatically saved.
Afterwards, the device goes back to the main screen.
• If a completely dierent program is needed, then press
the “RESET” button located on the main panel of the
thermostat to reset the device (it deletes both the
program and the basic settings). Following this, adjust
To Next Page
Loading...
