Replacing the Desiccant Wheel
Assembly (continued)
7 Remove four bolts securing the wheel assembly to the frame, then
remove the desiccant wheel assembly from the dryer.
8 Position the new wheel assembly on the frame, with the motor to the
right, as viewed from the front.
9 Bolt the wheel assembly to the frame.
10 Reconnect the motor wires.
11 Reconnect the hoses and RTDs to their original positions.
12 Reinstall the metal control cabinet cover using the original hardware.
13 Bolt the front plastic cover in place, and reconnect the wires to the dis-
play board and loader switch(es).
14 Bolt the rear plastic cover in place.
6
Troubleshooting
Troublesho oti ng l 6-35
To Next Page
Loading...
