4-42 l Operati on
How to Use the Supervisor’s
Password (continued)
5 This is the screen where you will need to enter the supervisor's password.
The default supervisory password in 0210. Enter this number to make changes
to screens where the supervisor’s password is necessary to use or change a
function of the dryer.
Be sure to push “Enter” after entering the password. If the password is
entered successfully, screen 87 will be displayed.
You can now make changes to screens where the supervisor’s password is
required. Once the desired parameter has been changed, follow the previous
steps to go to screen 88 (see the flow chart on page 4-9).
Push the Select Category button under “No”. Once it begins to flash, push the
Adjust Setpoint button to display “Yes”, then push “Enter”. Push the Menu
button to return to the main display.
NOTE: The supervisor's password can be changed by going to screen 89, see page 4-9, for
the map of the screens. See page 4-33, screen 89 for additional information on changing the
supervisory password.
VALID SUPERVISOR
PASSWORD ENTERED
LOGOUT SUPERVISOR
PASSWORD YES
✐
ENTER PASSWORD
0210
To Next Page
Loading...
