CONCORD Wanderer - Attaching and Removing the Rear Wheels; Unfolding and Folding up the Stroller

2928
_ ATTACHING AND REMOVING THE REAR WHEELS
To attach the real wheel, press and
hold the push-button (18) and insert
it into the socket on the CONCORD
WANDERER, pushing it until you
hear it click into place.
To remove the real wheel, press and
hold the push-button (18) and pull
the wheel out of the socket on the
stroller.
_ UNFOLDING AND FOLDING UP THE STROLLER
Use the handlebar (02) to pull the
CONCORD WANDERER upwards, so
that it unfolds itself. Keep pulling
upwards until the stroller has
unfolded completely and you hear it
lock into place.
Always make sure you check that the
closures have locked properly into place.
Now place the seat unit (04) (see
FITTING AND REMOVING THE
SEAT UNIT) or a CONCORD-
approved accessory into the
ProFix sockets (15).
WARNING!
• Keep the child away from the moving parts when these are being operated
by a responsible adult.
• The occurrence of cutting, pressure and crushing points during these
procedures are inevitable.
To unfold the CONCORD WANDERER, lie the stroller on a flat and
clean surface with the handlebar (02) pointing upwards and release the
transportation lock (12).
Before folding up the CONCORD WANDERER, lock the safety brake into
place (see USING THE SAFETY BRAKE) and then remove all CONCORD
accessories (CONCORD AIR, CONCORD SLEEPER, CONCORD SCOUT or
CONCORD SNUG).
To make the stroller easier to handle and to ensure it folds up smaller,
you can remove the seat unit (04) before folding it up (see FITTING AND
REMOVING THE SEAT UNIT).
Press and hold the adjustment knobs (03) and fold
the handlebar (02) down as far as it will go (see
ADJUSTING THE HANDLEBAR).