Confer Plastics CCX-AG

Need help?

Do you have a question about the Confer Plastics CCX-AG and is the answer not in the manual?

Summary

Confer Above Ground Curve Step System Assembly and Installation Manual

Model CCX-AG Assembly Instructions

Step 1: Attach Panel Brace

Instructions for securing the panel brace to the side panels.

Step 2: Attach Panel Extensions

Guide for attaching the panel extensions to the side panels.

Step 3: Insert Curved Riser Tabs

Procedure for aligning and inserting the lower tabs of curved risers.

Step 4: Secure Curved Riser Tabs

Instructions for tapping curved riser tabs into place using a rubber mallet.

Step 5: Install Remaining Curved Risers

Instructions for installing the rest of the curved risers into the side panels.

Step 7: Foot Pad Installation - Flat Bottom Pools

Details on installing foot pads (#1 facing up) for flat bottom pools.

Step 8: Foot Pad Installation - Tapered Bottom Pools

Details on installing foot pads (#1 and #2) for pools with a tapered bottom.

Step 9: Install Front Foot Pads

Guidance on installing front foot pads based on pool bottom type.

Step 10: Fill Step with Sand (Ballast)

Instructions for filling the step panels with sand for ballast.

Step 11: Install First Tread

Procedure for installing the first tread onto the side panels.

Step 12: Install Remaining Treads

Step 13: Install Lower Handrail Posts

Step 14: Install Upper Handrail Posts

Step 15: Attach Deck Connectors

Step 16: Place Handrails

Step 17: Submerge Step to Remove Air

Procedure for removing air from the step by submerging it in water.

Step 18: Attach to Deck and Handrail Posts

Instructions for securing the step to the pool deck and handrail posts.

Confer Curve Step Add-On Instructions

Step 19: Install Add-On Panel

Step 20: Install Add-On Foot Pad

Step 21: Slide Large Flex Riser

Step 22: Insert Flex Riser Tab

Step 23: Attach Final Foot Pad

Step 24: Secure Tread Support

Step 25: Add Sand to Add-On Panel

Instructions for filling the add-on panel with an additional 30 lbs of sand.

Step 26: Align Flex Riser and Tread Support

Step 27: Install Large Curved Tread

Step 28: Secure Large Curved Tread to Panel

Step 29: Install First Base Tread

Step 30: Install Short Handrail Post

Step 31: Install Medium Flex Riser

Step 32: Install Medium Curved Tread

Step 33: Install Second Base Tread

Step 34: Install Long Handrail Post

Step 35: Install Small Flex Riser and Tread

Step 36: Install Third Base Tread

Step 37: Slide Tread Filler

Step 38: Attach Tread Extension

Step 39: Install Top Base Tread

Step 40: Install Handrail Posts (Add-On)

Step 41: Attach Deck Connectors (Add-On)

Step 42: Place Handrails (Add-On)

Place Step in Pool

Final instructions to place the assembled step into the pool, referencing previous steps.

Safety Information

General Safety Precautions

Important safety guidelines for using tools and the pool step.

Weight Limit and Usage Restrictions

Information on maximum weight capacity and proper use of the step.