Page3
Mount the mounting plate onto outlet
box by the 2 srews, spring washers and
flat washers.(Using explosion screws(not
provided) for concrete).
36. Mounting
plate
Hang the ball joint and the fan onto the
bracket. Make sure the guide pin of
bracket is fitted into slot of ball joint.
10. Canopy
34. Ball Joint
Assemble the fan blade between the
blade bracket and blade holder, then
tighten the screws together with flat
washer.
.
9. Male/Female Connectors
2. Terminal Block
Insert the remote control receiver into
the space between the spherical
connection and mounting plate, then
fix the sensor on the ceiling.(see the
above figure).
8. Remote
Control Receiver
THE INSTALLSTION
POSITION OF SENSOR
Cable connection
To Next Page
Loading...