CONGA 9090 AI - Water Tank Installation; Initial Cleaning Cycle

30 | CONGA 9090 AI
ENGELSK
Water tank installation
Note
It is not suggested to use the scrubbing function for the rst-time use.
- Open the tank’s silicone cover, ll the tank with water carefully so water
does not come out. Make sure the silicone cover is properly closed to
avoid water from leaking. Do not immerse the water tank. Fig. 8.
- Install the tank in the robot following the indicated direction. Make sure
the clip is properly fastened. Fig. 9.
- Manually press the tabs on both sides of the Wet & dry tank and push
it into its correct position. You will hear a click when it is properly xed.
Fig. 10.
Recommendations
- Do not use the scrubbing function while the robot is unattended.
- Remove the mop bracket when the robot is charging or not in use.
- If there are carpets in the house, set Restricted Areas to avoid the robot
from passing over them.
- Add some drops of cleaning agent (not corrosive) if considered neces-
sary.
- To remove the mop bracket, press the release button and pull from it
outwards.
Warnings
- Using cleaning agents in excess might block water outlets.
- In order to achieve perfect scrubbing, it is suggested to moisten the
mop before using it.
First cleaning
- Once the robot and the charging base are completely installed, follow
these steps before scheduling the rst cleaning cycle.
- First of all, the robot must be fully charged. It is suggested to allow the
robot to charge overnight. When it is fully charged, it may carry out the
rst cleaning cycle and save the rst map. To do so, activate Auto clean-
ing mode and Eco power level. It is very important to follow these indi-
cations for the robot to recognize each and every corner in the house
and to create a complete map.
- If your house is too big and the robot runs out of battery, it returns to the
charging base, saves the full map and those that have not been com-
pleted, and once it is charged again, it resumes the cleaning cycle from
the point it has stopped until it maps the whole surface.
The robot keeps on mapping constantly, therefore it adapts inde-
pendently to each house’s features and continuously improves previous
maps.