CONGA 9090 AI - Robot Operation; Robot Button Functions; Automatic Cleaning Mode; Returning to Charging Base

CONGA 9090 AI | 31
ENGLESK
4. OPERATION
- The indicator light will change from oscillating orange to steady blue
when the battery is fully charged and the robot is ready to be used.
- The robot cannot operate with low battery.
Recommendation
Remove all cables and obstacles from the oor before operating the robot
in order to avoid accidents and damage.
Robot buttons. Fig. 11.
Automatic mode
- Press the power button on the robot for it to start cleaning automati-
cally, rst a cleaning cycle in Edge mode and then another cycle in an
organised zigzag motion, recognising which areas it has cleaned and
which ones it has not. The robot will automatically plan the cleaning
route as it is cleaning. If during this mode the robot is controlled manu-
ally, the robot will calculate the route again and could go through previ-
ously cleaned areas. In order to ensure ecient cleaning, do not operate
it manually during auto mode cleaning.
- Thanks to its Total Surface 3.0 technology, if the battery is low the robot
will smartly return to the charging base automatically and, once it is
fully charged, it will resume the cleaning process from the same point,
oering a high-eciency cleaning. In order to optimise the whole pro-
cess, the robot will automatically calculate the necessary charging time
according to the surface to be cleaned. During cleaning, the robot will
stop briey to evaluate the area and calculate the cleaning route (this
stop will vary depending on the house conditions).
Note
The robot cleans in an organised way and per 4x4 m squared areas, there-
fore it might leave the room where it is cleaning to nish o the delimited
area. Do not worry, the robot will clean all the accessible surface.
Back home mode
- Press the Back home button, the buttons will be oscillating orange.
- This mode can be activated during any other cleaning cycle and the ro-
bot will stop cleaning and return to the charging automatically.
- The robot will take the shortest route back to the charging base thanks
to its map memorizing and the smart back home function.
- When a cleaning cycle has been completed or the robot’s battery is low,
thanks to its Total Surface 3.0 technology, the robot will also return to