CONGA 9090 AI - Remote Control Functions; Remote Control Pairing; Available Cleaning Modes

32 | CONGA 9090 AI
ENGELSK
the charging base to avoid running out of battery. Once the robot has
recharged, it will resume cleaning from the point it has stopped.
Recommendation
Remove the Wet & dry tank during charging.
Remote control. Fig. 12.
- Scheduling
- Power levels (Turbo/Normal/Eco)
- Back home
- Manual control
- On/Pause
- Edge mode
Remote control binding
- If the robot does not respond to the remote control, follow the below
steps:
- Press the Edge mode button on the remote control for 5 seconds for the
remote control to enter pairing mode. The screen will display 8888.
- The remote receiver will be activated in 5 seconds and will enter pairing
mode. The remote control’s signal is received and the remote control
returns to normal status. The display will show pairing is completed.
- If the pairing process is unsuccessful, the remote control will display
8888 and will exit the pairing mode after 30 seconds.
The following modes and operations can be activated from the remote
control.
Modes
The rst time the robot is operated, it will map and save the whole house’s
map by means of its laser before starting the cleaning cycle. Use the robot
in Auto mode and Eco power level, this way you will ensure the robot mem-
orises the full map.
Note
Make sure the indicator light is lit up in blue before starting cleaning, indi-
cating it is activated.
If not, press any button on the remote control to wake it up.
Automatic mode. Fig. 13.
- Press the power button on the remote control for it to start cleaning au-
tomatically, rst a cleaning cycle in Edge mode and then another cycle
in an organised zigzag motion, recognising which areas it has cleaned