CONGA 9090 AI - Edge Cleaning Mode Operation; Back Home Mode Operation

CONGA 9090 AI | 33
ENGLESK
and which ones it has not. The robot will automatically plan the clean-
ing route as it is cleaning. If during this mode the robot is controlled
manually, the robot will calculate the route again and could go through
previously cleaned areas. In order to ensure ecient cleaning, do not
operate it manually during auto mode cleaning.
- Thanks to its Total Surface 3.0 technology, if the battery is low the robot
will smartly return to the charging base automatically and, once it is
fully charged, it will resume the cleaning process from the same point,
oering a high-eciency cleaning. During cleaning, the robot will stop
briey to evaluate the area and calculate the cleaning route (this stop
will vary depending on the house conditions).
Note
The robot cleans in an organised way and per 4x4 m squared areas, there-
fore it might leave the room where it is cleaning to nish o the delimited
area. Do not worry, the robot will clean all the accessible surface.
Edge mode. Fig. 14.
Press the Edge mode button on the remote control for the robot to start
cleaning under this mode. It will automatically start cleaning along all the
surface’s perimeters and then will return to the charging base direct and
automatically. If the robot has not started cleaning from the charging base,
it will return to the starting point.
Note
Press the power levels button to switch between the 3 modes: Turbo/Nor-
mal/Eco.
Back home Mode. Fig. 15.
- Press the Back home button on the remote control in order to send
the robot to the charging base. This function can be activated during
any other cleaning cycle and the robot will automatically return to the
charging base and stop the cleaning process. The robot will take the
shortest route back to the charging base thanks to its map memorizing
and the smart back home function.
- When a cleaning cycle has been completed or the robot’s battery is low,
thanks to its Total Surface 3.0 technology, the robot will also return to
the charging base to avoid running out of battery. Once the robot has
recharged, it will resume cleaning from the point it has stopped.
Warnings
- Remove the Wet & dry tank from the robot before charging it.