34 | CONGA 9090 AI
ENGELSK
- Make sure there are no obstacles in the room being cleaned to ensure
the robot can get to the charging base without problems.
Functions
Pause
While the robot is operating, press the power button on the App, the remote
control or on the robot to pause it and press the same button again to re-
sume cleaning.
Standby
The robot will automatically enter standby mode after 5 minutes of no op-
eration. Press the power button on the App, the remote control or on the
robot to start it up again.
Warnings
- After 12 hours of no operation, the robot will turn automatically o.
- The robot will not enter standby mode during charging.
Suction power level
Press the power levels button on the remote control to select the desired
power level. Choose between Eco (low power), Medium (medium power)
and Turbo (high power).
Scheduling
Warning
The robot cannot be scheduled from more than one device at a time. Make
sure to schedule it either from the mobile phone App or from the remote
control.
The robot is provided with a schedule function in order to provide a max-
imum-eciency cleaning. The time settings and the cleaning schedul-
ing must be carried out from the remote control. Once the robot has been
scheduled, it will automatically carry out the cleaning cycles every sched-
uled day.
Note
Make sure the robot is activated and that the indicator light is on before
scheduling any cleaning or setting time.
Current time. Fig. 16.
- Hold down the time button for 3 seconds. The rst 2 digits, indicating
the hour, will start blinking.
- Use the up and down direction buttons to set the current time. Then, use
To Next Page
Loading...
