CONGA 9090 AI | 35
ENGLESK
the left and right buttons to switch from hours to minutes and repeat
the before step. Fig. 17.
- Press the time button again to save the settings.
Scheduling cleaning tasks
- Hold down the schedule button for 3 seconds. The rst 2 digits, indicat-
ing the hour, will start blinking. Fig. 18.
- Use the up and down direction buttons to set the schedule time. Then,
use the left and right buttons to switch from hours to minutes and re-
peat the before step. Fig. 19.
- Press the schedule button again to save the settings.
- To cancel the scheduled cleaning, follow the below steps:
- Set the clock on the remote control at 00:00 a.m. and save it.
- Switch the robot o for 1 minute and switch it on again.
Note
The robot will beep to indicate all settings have been saved.
Warning
When the remote control’s batteries are replaced, the clock and schedule
times must be set again.
Articial intelligence
All modes operate with articial intelligence in order to optimise the clean-
ing cycles through obstacle detection and type of oor recognition. Make
sure the cleaning are is well illuminated (in rooms with poor lighting, it may
not detect objects). This way, the robot is able to recognise small objects
such as socks, cables, fan support feet or even pets. This allows the robot
to plan cleaning routes avoiding obstacles. It detects and recognises the
type of oor in each room and suggests cleaning tips on the type of brush
to be used or scrubbing level to be selected for that specic room according
to the type of oor. This information will be displayed on the App as long as
the robot is linked.
Indicator light
- Operating: Steady white light.
- Low battery/back home mode: oscillating orange light.
- Charging: Oscillating orange ligh.
- Network conguration: Oscillating white light.
- Start-up/rmware update: Oscillating white light.
- Error: Red light ashes quickly.
- Tank and/or mop lack: steady red light.
To Next Page
Loading...
