40 | CONGA 9090 AI
ENGELSK
Free-fall sensors. Fig. 27.
Clean the free-fall sensors with a soft cloth regularly.
Warning
Always transport the product turned o and in its original package.
Visual detection sensor. Fig. 28
Clean the lens with a soft, clean cloth. Avoid using detergents or sprays
during clean-ups. These clean-ups must be made at least once a week, de-
pending on the use.
7. BATTERY REPLACEMENT AND CHARGING
- Do not use any other battery, power adapter or charging base than the
one ocially provided by Cecotec.
- Do not use non-rechargeable batteries.
- Do not remove, dismantle or attempt to repair the battery or the charg-
ing base.
- Do not place the charging base near heat sources.
- Do not use a wet cloth to wipe any of the parts of this product.
- If the robot is not going to be used for a long time, remove the battery
from the product and store it in a dry and safe place. It is suggested to
charge the battery every month in order to avoid damage to the battery.
- Do not dispose of waste batteries at will. It is suggested to hand them
over to professional organizations for correct treatment.
8. TROUBLESHOOTING
Problem
1. The robot does not start up or does not clean.
2. The robot cannot charge or return to the charging base.
3. The robot does not work properly.
4. The robot emits a strange noise during cleaning.
5. The robot does not clean eciently or dust leaks from the robot.
6. The robot could not connect to Wi-Fi.
7. The robot did not carry out the scheduled cleaning task.
8. The robot does not return to the charging base after spot cleaning or
after changing starting position.
9. The robot does not resume cleaning.
10. The robot is always oine.
To Next Page
Loading...
