CONGA 9090 AI - Silicone Brush Cleaning; Jalisco Brush Cleaning; Dust Tank Cleaning; High-Efficiency Filter Care

CONGA 9090 AI | 39
ENGLESK
Recommendation
Replace the main brush every 6-12 months to ensure ecient operating
(depending on the frequency and type of use).
Fig. 21.
- Main brush cover
- Tab
- Main brush
- Compartment
Silicone brush. Fig. 22.
- To clean the silicone brush, follow the instructions on the previous sec-
tion to remove it from the robot and wash it with water and soap.
- Dry it thoroughly before assembling it back in order to ensure ecient
operation.
Jalisco brush. Fig. 23.
- To clean the Jalisco brush, follow the previous section’s stepsand clean
it with water.
- Dry it thoroughly before assembling it back in order to ensure ecient
operation.
Dust tank. Fig. 24.
- Take the dust tank out.
- Open the dust tank cover and empty it.
- Use the cleaning brush to clean the inside of the dust tank.
- Install the dust tank back in the robot.
High-eciency lter. Fig. 25.
Remove the high-eciency lter and shake it to remove all the dust.
Note
Replace the high-eciency lter every 3 months depending on the frequen-
cy and type of use. Clean the lter periodically with a brush to avoid block-
age. Do not use water or detergents.
Side brush. Fig. 26.
Remove and clean the side brushes regularly.
Recommendation
In order to ensure a perfect cleaning, it is suggested to replace the side
brushes every 3 months, depending on the frequency and type of use.