CONGA 9090 AI - App-Controlled Spot Mode; App-Controlled Restricted Areas; App-Controlled Twice Mode; Cleaning and Maintenance

38 | CONGA 9090 AI
ENGELSK
than 1 area at the same time. The robot will only clean the area selected
in the map, therefore it will go to the point and return to the base with-
out vacuuming.
- It can only be activated from the App.
Spot mode
- Select this mode if you want to thoroughly clean a specic point in the
map, making the most of the robot’s maximum power. The robot will
clean a 2x2 m zone in zigzag motion and then will return directly to the
charging base when cleaning is completed. The robot will only clean the
area selected on the map, therefore it will go to the point and return to
the base without vacuuming.
- It can only be activated from the App.
Restricted area mode
- Select this mode and delimit in the map specic areas where you do not
want the robot to clean. You can set more than 1 restricted area at the
same time on the map.
- It can only be activated from the App. It is recommended to set starts as
restricted areas to avoid setbacks.
Twice mode
- Use this mode to carry out a deep, thorough cleaning of your home.
- It can be combined with Edge, Spiral, Spot or Smart Area modes. The
robot will carry out 2 full cleaning cycles and then will return directly to
the charging base.
Final cleaning
Before returning to the charging base, the robot moves forward and back-
ward several times in order to eliminate any rests of dust from the brush.
6. CLEANING AND MAINTENANCE
Main brush
- Turn the robot around and press the main brush’s release button to take
the cover out.
- Take the main brush out and clean the compartment.
- Clean the main brush with the provided tools and use water and soap if
necessary.
- Place the main brush in its position and fasten the cover’s clip.