CONGA 9090 AI - App-Controlled Edge Mode; App-Controlled Spiral Mode; App-Controlled Scrubbing Mode; App-Controlled Manual Mode

CONGA 9090 AI | 37
ENGLESK
space, it will carry out a rst cleaning cycle in Edge mode and then in
zigzag motion to complete the surface. Once it has nished, it will di-
rectly return to the charging base.
- It can be activated from the App or the remote control.
Note
The robot could leave the room to complete the cleaning cycle in some of
the quadrants. This will not aect the robot’s operating, do not worry.
Edge mode
- Select this mode for the robot to clean along walls and furniture.
- It can be activated from the App or the remote control.
Spiral mode
- When this mode is selected, the robot will start cleaning in a specic
point, by moving in an outward spiral motion and then returning to the
starting point in an inward spiral motion at maximum power. Then, it
will return directly to the charging base.
- It can only be activated from the App.
Scrubbing mode
- When this mode is activated, the robot moves in a swaying motion,
simulating real scrubbing moves. It starts o cleaning in Edge mode,
then in zigzag motion and nally returns to the charging base taking the
straightest way back home.
- It can only be activated from the App.
Manual mode
- To carry out manual cleaning, use the direction buttons on the remote
control or on the App to take the robot to the specic points where you
want it to clean.
- It can be activated from the App or the remote control.
Back home mode
- Select this mode at any point of any cleaning cycle and during any of the
modes, the robot will automatically return to the charging base.
- It can be activated from the robot, the remote control or the App.
Smart area mode
- Once the home’s map has been saved, select this mode for the robot to
clean a specic area in zigzag motion. The robot will clean the selected
area and then will return directly to the charging base. You can set more