Conqueror CIL-CD800S - 4 Automated Instructions & Programming; Ready Status; Operational Instructions; Adjustment Methods

www.conquerordoors.com
6
4. Automated instructions & programming
Open the cover as Fig16 showing before
adjusting.
CIL-CD800S (Chain) and
CIL-BD800S (Belt) Opener Quick
Set Up Guide
Button +, – and P are used for the set up (Fig. Q1)
• Set the open/close limits
NOTE: The door, traveler and chain/belt spool must be engaged. The opening stop must be installed
(Fig. 2)
1. Press & Hold button P until is displayed
2. Briefly press button +
3. The garage door will now automatically open and close for 2 cycles.
• Adjust Closing Clearance
1. Press & Hold button P until A is displayed
2. Scroll to using P button
3. Briefly press + or – to adjust the closing clearance from 0 to 9 (default: 2)
4. Press P to confirm and enter the next setting
• Opening Sensitivity
1. Press & Hold button P until A is displayed
2. Scroll to using P button
3. Briefly press + or – to adjust the opening sensitivity from 0 to 9 (default 3)
4. Press P to confirm and enter the next setting
• Closing Sensitivity
1. Press & Hold button P until A is displayed
2. Scroll to using P button
Fig. Q1
Fig.
+ -
P