Conrad SL1007 - PIR Detection Mode Usage; Capturing Still Images; Recording Video Clips

27
Using The Camera in PIR Detection Mode
• Mount the camera to the tree or wall or other sturdy
object using either a supplied wall mounting device or
supplied mounting strap.
• Open the bottom housing and slide the switch to either
one of the CAM or PSET modes. At this point, you have 30
seconds to make any mode selection changes before
camera is ready to use.
• If you chose CAM mode then make sure your camera is in
the PIR mode and not Time Lapse (TLS). If you are not
sure, please follow the “Camera setup and program”
above to set the camera into the proper mode.
To Capture Images, make sure display reads CAM:
Once in CAM mode, if the display does not read CAM then,
• Press the [M] button once.
• If the LCD display does not show word CAM in blinking.
• Press the [UP] button ONCE to toggle to Camera mode.
• Press the [OK] button and then [M] Button to exit.
To Capture Videos, make sure display reads VIDEO:
Once in CAM mode, if the display does not read VIDEO then,
• Press the [M] button once.
• If the LCD display does not show word VIDEO in blinking.
• Press the [UP] button ONCE to toggle to Video mode.