15
Camera Setup and Program
When the camera switch is first turned in the CAM location, the
internal LCD display shows the camera status. The following
information is present on this screen.
Passive Infrared Mode Time-Lapse / PIR Mode
If no buttons are pressed after 30 seconds the LCD display will
go to sleep mode and LCD display switch to show the capture
quality and enter 1-minute count down for user leave the
capture area, then camera enter PIR detection mode or Time
lapse mode. To wake up the camera by press UP or DOWN
button once, the LCD display will resume the status of camera.
Setting the Preset Program Selection Mode:
This camera is equipped with 2 Program selection toggle switch
settings. Make sure camera switch is in the OFF position
BEFORE changing any toggle switches.
NOTE: If you choose one of the Preset settings, your
camera will only function in PIR mode not Time Lapse
mode
• CAM - This allows the user to define what setting the
camera will use.
To Next Page
Loading...