29
Using The Camera In Time Lapse Mode
• Mount the camera to the tree or wall or other sturdy
object using either a supplied wall mounting device or
supplied mounting strap.
• Open the bottom housing and slide the switch to CAM
mode. At this point, you have 30 seconds to make any
mode selection changes before camera is ready to use.
• Make sure your camera is in Time Lapse (TLS) mode and
not PIR mode. If your not sure, please follow the “Camera
setup and program” above to set the camera into TLS
mode.
• 30 seconds after you’ve made your adjustments, the laser
beam will begin blinking and enter countdown mode. This
is your indication to leave the coverage area within one
minute, then the camera will enter Time Lapse Mode.
To Next Page
Loading...