Consort C6010 - Data-Logging; Usb

C6010 • C6020 • C6030
C6010 • C6020 • C6030
C6010 • C6020 • C6030 C6010 • C6020 • C6030
8
8
Data-logging
Data-logging
1.
Press
MODE
.
2.
Select [MENU] and press
OK
.
3.
Select [DATA] and press
OK
.
Start the data-logging:
1.
Select [ACTIVATE] and press
OK
.
2.
Decide whether data-logging should be carried out or not and press
OK
.
3.
Select [CONTINUOUS] and press
OK
.
4.
Decide whether the oldest data should be overwritten when the memory limit
is reached or not and press
OK
.
5.
Select [INTERVAL] and press
OK
.
6.
Select the desired time interval between the data-logging and press
OK
.
7.
Return to the measurements by pressing
MODE
.
8.
The data-logging starts according to the previous settings while the display
shows the logging-number e.g. [LOG.00027].
Process the stored values:
1.
Select [PROCESS] and press
OK
.
2.
Select [TABLE] or [SEND] to display or send the stored data and press
OK
to
con ti nue. Follow the in struc tions on the screen.
Erase the stored values:
1.
Select [PROCESS] and press
OK
.
2.
Select [ERASE] and press
OK
. Follow the in struc tions on the screen.
USB
1.
Press
MODE
.
2.
Select [MENU] and press
OK
.
3
.
Select [USB] and press
OK
.
4
.
Select [INTERVAL] and press
OK
.
5.
Select the desired in terval between the trans mitted data and press
OK
. Pre-set
to zero if no automatic transmit ting is re qui red.
6.
Select [BAUD] and press
OK
.
7.
Select the desired baud rate and press
OK
.
•
You can download a suitable USB driver from www.consort.be.
User standard tables
1.
Press
MODE
.
2.
Select [MENU] and press
OK
.
3.
Select [USER TABLES] and press
OK
.
4.
Select [pH buffers] or [S/cm standards] and press
OK
.
5.
Follow the in struc tions on the screen to enter the different values. The value
for 25°C is obligatory!