Contax T3 - Page 33

<Aperture-priority Mode Exposure Control Table>
The available combinations of shutter speeds and apertures set in
the aperture-priority mode are shown in this table.
1 While holding the dial
lock release button
depressed, rotate the
aperture dial to set the
aperture as desired.
O Press the shutter
^ release button to make
the photograph.
16" 8‘ 4 ' 2 " 1" 1/2 1/4 1/8 1/15 1/30 1/60 1/125 1/250 1 / 5001/1000 sec
Hi If the available light on the subject is too bright for the pre-programmed
automatic-linkage range, the program will automatically shift to get a
correct esposure.
• When shooting dark interiors, night scenes, or occasions where
flash is required, it is recommended to set the camera to “P”, or else
set the aperture to F2.8.
37