Contax T3 - Page 52

<Setting the Date and Time>
To set or correct the date and time proceed as follows:
® Press the mode button to display the data you wish to
change.
@ Press the select button so the number to be changed
blinks.
@ Press the set button to set the number to the desired value.
(The blinking in the time display indicates the second counter. Press
the set button together with a radio controlled time signal to set the
time accurately.)
® When setting is complete hold the select button depressed
until the number stops blinking.
<Changing the Data Back Battery>
The Data Back battery is a long-life lithium battery {CR2025) and
should last 3-4 years without needing replacement. As the battery
becomes depleted, the date and time imprint will become fainter,
and the LCD screen will fail to display properly. In this case,
change the battery as follows:
® Open the camera back,
remove the screw
securing the battery
cover, and open the
compartment.
(D Replace the old battery
with a new one, taking
care to insert with the
positive (+) polarity facing
outward, then replace the
compartment lid and
screw down.
• After replacing the battery, be
sure to reset the date and time.
Store Data Back batteries {CR2025) out of the reach of children. In the
event a battery is swallowed, seek medical attention immediately.
56