Contax T3 - Page 9

Display of battery capacity
' llBattery is full
IS^ battery will
'shortly
{BlinkingJj,
as soon as
possible
(Bl'r King):
cm Battery is eipty
<Battery Replacement>
The battery should be replaced
when the battery charge
indicator “ csi ” blinks in the
display panel. Turn off the
camera before replacing the
battery.
• Photographs can still be taken
even when the remaining battery
power indicator “ cai" begins
to blink, but the battery should
nonetheless be changed as soon
as possible. If the remaining
battery power falls below a
certain point, the “ (zzi ” mark on
the display panel will blink and
the camera will not operate.
• Due to individual manufacturing
characteristics, some batteries
may cause the battery power
indicator “ cai ” to blink
temporarily after the battery is
changed. If this occurs
immediately after changing a
battery, turn the power switch
OFF and then ON again; if the full
battery power indicator “ iMl ”
appears when the camera is
turned on again, the battery can
be used without problems.
13