Do you have a question about the Contec CMS8000 and is the answer not in the manual?
Category | Medical Equipment |
---|---|
Device Name | Contec CMS8000 |
Type | Patient Monitor |
ECG Lead Mode | 3-lead or 5-lead |
Resolution | 800 x 600 |
Power Supply | AC 100-240V, 50/60Hz |
Battery | Rechargeable lithium battery |
Operating Temperature | 5°C to 40°C |
Storage Temperature | -20°C to 55°C |
Display | TFT LCD |
Screen Size | 12.1 inches |
Parameters | ECG, RESP, NIBP, SpO2, TEMP, PR |
Interface | Ethernet, Nurse call |
Humidity | 15% to 95% non-condensing |
Battery Life | Approximately 4 hours |
Lists the vital signs and parameters monitored by the CMS8000 patient monitor.
Critical safety precautions and warnings for operating the patient monitor.
Comprehensive list of system prompts, causes, and recommended measures for errors.
Troubleshooting steps for when the patient monitor fails to power on.
Troubleshooting no ECG wave or noisy ECG signals on the monitor.
Addressing no SpO2 signal or noise in SpO2 waves.
Common issues and fixes for NIBP measurement failures.
Step-by-step instructions for safely disassembling the patient monitor.
Detailed steps for removing and installing the main power supply module.
Guide for replacing the SpO2 module of the patient monitor.
Procedures for removing and installing the main circuit board.
Instructions for replacing the AC/DC power supply module.