How to fix SpO2 and Pulse Rate display issues on Contec Medical Equipment?
If the SpO2 and Pulse Rate are not displayed normally on your Contec Medical Equipment, it might be due to incorrect finger placement. Ensure the finger is properly positioned. If the issue continues, the patient’s SpO2 might be too low to be detected. Try again, and if you are sure the device works correctly, seek a diagnosis from a hospital.
What to do if my Contec CMS50D+ device can't be turned on?
If your Contec Medical Equipment device isn't turning on, the battery may be drained or almost drained. Try replacing the batteries. Also, ensure the batteries are installed correctly; reinstall them if necessary. If the problem persists, it could indicate a device malfunction, and you should contact the local service center.
Why does the display turn off suddenly on my Contec Medical Equipment?
If the display on your Contec Medical Equipment is off suddenly, it could be normal as the product enters standby mode when no signal is detected within 5 seconds. Alternatively, the batteries might be drained or almost drained, so try changing them.
What to do if SpO2 and Pulse Rate are not displayed stably on Contec CMS50D+?
If the SpO2 and Pulse Rate are not displayed stably on your Contec Medical Equipment, make sure the finger is placed deeply enough inside the device. If not, place the finger properly and try again. Also, ensure the patient remains calm and still, as movement can interfere with the readings.
Provides guidance on safe usage and periodic checks of the pulse oximeter.
Highlights crucial safety warnings, including explosive hazards and patient precautions.
Details the primary performance indicators and display functions of the device.
Lists the measurement ranges, accuracy, and resolution of SpO2 and pulse rate.
Step-by-step guide on how to correctly apply the finger clip for measurement.
Guides users through navigating the device's menu for settings and functions.
Instructions for setting custom high and low alarm thresholds for measurements.
Details how to configure the device for storing measurement data.
General| Type | Pulse Oximeter |
|---|---|
| Model | CMS50D+ |
| Measurement Parameters | SpO2, PR, PI |
| SpO2 Measurement Range | 0% - 100% |
| PR Measurement Range | 30 bpm - 250 bpm |
| Display | OLED |
| Battery Life | 30 hours |
| Power Consumption | Less than 30mA |
| Operating Temperature | 5°C - 40°C |
| SpO2 Accuracy | ±2% (70% to 100%) |
| PR Accuracy | ±2 bpm or ±2% (whichever is greater) |
| PI Measurement Range | 0% - 20% |
| Battery Type | 2 x AAA batteries |
| Relative Humidity | 15% - 80% |
| Resolution | 128x64 pixels |
| Weight | 50g (without batteries) |
| Storage Temperature | -20°C - 55°C |
To Next Page
