F. Standby mode
If the measuring finger out of the device on the
measuring interface, The product will enter standby
mode when no signal is in the product within 5
seconds.
The device can't being enter standby mode when it is in
a state of storing.
6.2 Attention for Operation
A. Please check the device before using, and confirm that
it can work normally.
B. The finger should be in a proper position (see
C. the attached illustration of Figure 4 for reference), or
else it may result in inaccurate measure.
D. The SpO
2
sensor and photoelectric receiving tube
should be arranged in a way with the subject’s arteriole
in a position there between.
E. The SpO
2
sensor should not be used at a location or
limb tied with arterial canal or blood pressure cuff or
receiving intravenous injection.
F. Do not fix the SpO
2
sensor with adhesive or else it may
result in venous pulsation and inaccurate measure of
SpO
2
and pulse rate.
G. Excessive ambient light may affect the measuring
result. It includes fluorescent lamp, dual ruby light,
infrared heater, direct sunlight and etc.
To Next Page
Loading...
